Measurement of viscosity is a subject covered by various global standards, aiming to establish a shared comprehension of testing methods and quality parameters between sellers and purchasers. The following list summarizes the viscosity measurement test methods outlined by ASTM.
- C474: Testing Methods for Gypsum Board Construction Joint Treatment Materials
- C965: Practices to Measure Glass Viscosity Above Softening Point
- C1276: Method to Measure Mold Powders' Viscosity Above Melting Point Using Rotational Viscometer
- D115: Testing Methods for Varnishes Used in Electrical Insulation
- D562: Testing Paints Consistency Using Stormer Viscometer
- D789: Determination of Relative Viscosity, Melting Point, and Moisture Content of Polyamide (PA)
- D803: Test Methods for Tall Oil Testing
- D1074: Compressive Strength Testing of Bituminous Mixtures
- D1076: Specification for Rubber-Concentrated, Ammonia Preserved, Creamed, and Centrifuged Natural Latex
- D1084: Adhesives Viscosity Test Methods
- D1337: Adhesives Storage Life Testing by Viscosity and Bond Strength
- D1338: Determining the Working Life of Liquid or Paste Adhesives Using Viscosity and Bond Strength
- D1417: Testing Methods for Synthetic Rubber Lattices
- D1439: Testing Sodium Carboxymethyl-cellulose
- D1824: Measuring Apparent Viscosity of Plastisols and Organosols at Low Shear Rates with Brookfield Viscometer
- D1986: Determining Apparent Viscosity of Polyethylene Wax with Brookfield Viscometer
- D2196: Rheological Properties Testing on Non-Newtonian Materials using Rotational Viscometer
- D2243: Testing Freeze-Thaw Resistance of Waterborne Coatings
- D2364: Testing Hydroxyethyl-cellulose by Standard Methods
- D2556: Apparent Viscosity Testing of Adhesives with Shear Rate Dependent Flow Properties
- D2669: Apparent Viscosity Testing of Petroleum Waxes Compounded with Additives (Hot Melts)
- D2983: Low-Temperature Viscosity Testing of Automotive Fluid Lubricants
- D3236: Apparent Viscosity Testing of Hot Melt Adhesives and Coating Materials
- D3468: Standard Specification for Liquid-Applied Neoprene and Chlorosulfonated Polyethylene in Roofing and Waterproofing
- D3716: Standard Test Methods for Emulsion Polymers in Floor Polishes
- D3730: Standard Guide for High-Performance Interior Architectural Wall Coatings Testing
- D3791: Standard Practice for Evaluating Heat Effects on Asphalts
- D3794: Guide for Coil Coatings Testing
- D3806: Standard Test Method for Small-Scale Fire-Retardant Paints Evaluation
- D4016: Standard Test Method for Chemical Grouts Viscosity using the Brookfield Viscometer
- D4143: Standard Guide for Latex Vehicles Testing
- D4212: Standard Test Method for Viscosity using Dip-Type Viscosity Cups
- D4280: Standard Specification for Extended Life Retroreflective Pavement Markers
- D4402: Standard Test Method for Asphalt Viscosity using a Rotational Viscometer
- D4712: Guide for Industrial Water-Reducible Coatings Testing (withdrawn 2017)
- D4800: Standard Guide for Adhesives Classification and Specification
- D4878: Standard Test Methods for Polyurethane Raw Materials: Polyols Viscosity Determination
- D4889: Standard Test Methods for Polyurethane Raw Materials: Crude or Modified Isocyanates Viscosity Determination
- D5018: Standard Test Method for Shear Viscosity of Coal-Tar and Petroleum Pitches
- D5133: Standard Test Method for Low Temperature, Low Shear Rate, Viscosity/Temperature Dependence of Lubricating Oils using Temperature-Scanning Technique
- D5146: Standard Guide to Solvent-Borne Architectural Coatings Testing
- D5324: Standard Guide for Water-Borne Architectural Coatings Testing
- D5400: Standard Test Methods for Hydroxypropyl cellulose
- D6080: Standard Practice for Defining Hydraulic Fluids Viscosity Characteristics
- D6083: Specification for Liquid Applied Acrylic Coating in Roofing (withdrawn 2014, no replacement)
- D6267: Standard Test Method for Apparent Viscosity of Hydrocarbon Resins at Elevated Temperatures
- D6373: Standard Specification for Performance Graded Asphalt Binder
- D6577: Standard Guide for Industrial Protective Coatings Testing
- D6895: Standard Test Method for Rotational Viscosity of Heavy-Duty Diesel Drain Oils at 100 °C
This information has been sourced, reviewed and adapted from materials provided by Paul N. Gardner Company, Inc.
For more information on this source, please visit Paul N. Gardner Company, Inc.