Written by AZoMSep 7 2001
|
|
Polymer Type |
Thermoplastic |
Advantages |
Good cost/performance ratio. Better heat distortion temperature and flexural modulus than 40% glass fibre reinforced PPS. |
Disadvantages |
Reduced volume resistivity, dielectric strength, tensile strength, elongation at break and notched izod impact strength when compared with 40% glass fibre reinforced PPS. |
Typical Properties |
| Density (g/cm3) | 1.8 | Surface Hardness | RR121 | Tensile Strength (MPa) | 91 | Flexural Modulus (GPa) | 13.8 | Notched Izod (kJ/m) | 0.031 | Linear Expansion (/°C x 10-5) | 2.8 | Elongation at Break (%) | 0.6 | Strain at Yield (%) | N/A | Max. Operating Temp. (°C) | 200 | Water Absorption (%) | 0.03 | Oxygen Index (%) | 53 | Flammability UL94 | V0 | Volume Resistivity (log ohm.cm) | 15.3 | Dielectric Strength (MV/m) | 13.4 | Dissipation Factor 1kHz | 0.017 | Dielectric Constant 1kHz | 4.6 | HDT @ 0.45 MPa (°C) | 260+ | HDT @ 1.80 MPa (°C) | 244 | Material. Drying hrs @ (°C) | 6 @150 | Melting Temp. Range (°C) | 315 - 360 | Mould Shrinkage (%) | 0.3 | Mould Temp. Range (°C) | 40 - 140 | |
Applications |
Automotive headlamps, housings, sensors, under-bonnet parts exposed to oil, petrol and hydraulic fluid, boxes for electronic circuits. Coil bobbins, connectors, relays and circuit breakers. Pumps and valves for the chemical and petrochemical industries. Precision mechanical parts. |
Source : Abstracted from Plascams For more information on Plascams please visit RAPRA Technology Ltd. |