Stacked MoS₂ Monolayers Produce Ultralow-Threshold Lasing-Like Emission At Room Temperature

By separating stacked MoS2 monolayers with organic spacers, researchers tested whether a solution-processed thin film could retain strong excitonic behavior while giving light more active material to interact with.

Paper: Room-temperature continuous-wave lasing-like emission from solution-processed bulk monolayer MoS2 thin films. Image Credit: Dimitris Leonidas

Paper: Room-temperature continuous-wave lasing-like emission from solution-processed bulk monolayer MoS2 thin films. Image Credit: Dimitris Leonidas

*Important notice: This news reports on an unedited version of an accepted paper and is awaiting final editing. Therefore, the paper should not be regarded as conclusive or treated as established information.

In a recent research article published in the journal Nature Communications, researchers developed a solution-processed, bulk monolayer MoS2 thin-film architecture that preserves monolayer excitonic properties while providing a tunable optical-gain volume in films that can be made over large areas for room-temperature, continuous-wave, lasing-like emission.

TMDs as Large-Area Gain Media

Monolayer transition metal dichalcogenides (TMDs), such as MoS2, are studied as laser gain media because they have a direct bandgap and strong excitonic effects at room temperature.

Traditional TMD lasers typically use materials obtained by mechanical exfoliation or high-temperature chemical vapor deposition (CVD). Both methods have limitations: exfoliated monolayers are restricted in size and large-area production, while CVD processes involve high temperatures that are incompatible with many substrate types and complex device architectures.

The atomically thin nature of these monolayers restricts the available optical gain volume, limiting lasing performance. Chemical or electrochemical exfoliation can instead create solution-processable TMD nanosheet inks.

These inks enable fabrication of large-area thin films for applications including photonics. However, solution-processed TMDs have historically shown light-emission quenching due to interlayer electronic coupling and defects, and producing lasing-like emission from such films remains difficult.

The researchers developed a solution-processed bulk monolayer MoS2 (BM-MoS2) thin film composed of electronically decoupled monolayer MoS2 nanosheets separated by organic ligands. This architecture preserves monolayer-like excitonic properties while increasing the optical gain volume available to the cavity.

Solution-Processed BM-MoS2 Fabrication

The BM-MoS2 films were fabricated through polymer-assisted electrochemical intercalation and exfoliation of bulk MoS2 crystals. In this process, tetraheptylammonium bromide (THAB) and poly(vinylpyrrolidone) (PVP) were dissolved in dimethylformamide (DMF), which served as the electrolyte.

Applying a negative voltage to the MoS2 cathode drove cations and PVP molecules into the van der Waals gaps of bulk MoS2, causing the crystals to expand. Sonication then exfoliated the expanded crystal into monolayer MoS2 nanosheets coated with PVP ligands. Solvent exchange and centrifugation removed thicker nanosheets and produced a stable colloidal ink in isopropanol.

The PVP ligands electronically decouple adjacent MoS2 layers. The ink was spray-coated onto a reflective substrate consisting of a silver (Ag) film topped with a 55-nm polymethyl methacrylate (PMMA) layer, forming the BM-MoS2 thin film.

These films consist of vertically stacked monolayer MoS2 nanosheets alternating with organic spacer layers, forming a hybrid superlattice structure. BM-MoS2 thickness can be adjusted through spray-coating time, which changes the optical gain volume.

Silica microspheres were then spin-coated onto the BM-MoS2 film to create microsphere WGM resonators, in which light circulates around the sphere perimeter and receives optical feedback and confinement.

Characterization techniques included grazing-incidence wide-angle X-ray scattering (GIWAXS), high-resolution transmission electron microscopy (HRTEM), atomic force microscopy (AFM), Raman and photoluminescence spectroscopy, and finite-difference time-domain (FDTD) optical simulations.

Microsphere WGM Lasing-Like Behavior

The BM-MoS2 films retained monolayer MoS2 excitonic features while providing an extended gain volume through layered stacking with organic spacers. GIWAXS and microscopy confirmed an oriented layered structure with a 2.64 nm repeat spacing.

PVP electronically decoupled adjacent layers, suppressing the interlayer interactions that give few-layer MoS2 an indirect bandgap and preserving strong excitonic emission characteristic of monolayers. Integration with silica microspheres produced WGM resonances with measured quality factors above 10³ in the excitonic region above the threshold-like crossover.

Under continuous-wave optical pumping at room temperature, the devices exhibited several correlated lasing-like signatures. These included a threshold-like crossover in emission intensity at an ultralow incident pump power of about 1.4 nW, linewidth narrowing of TE WGM modes while neighboring TM modes showed no comparable threshold feature, and pump-induced polarization selection effects consistent with optical gain and a lasing interpretation.

TE and TM modes differ in the orientation of their electric fields, which affects how strongly they couple to the excitonic dipoles in MoS2. Microsphere focusing may raise the local threshold density from an apparent ~0.01 W cm-² to as much as ~0.1 W cm-².

The thickness-tunable BM-MoS2 films increased optical confinement compared with isolated monolayers, but thicker films also reduced the passive cavity quality factor through absorption and mode leakage.

The five-unit film crossed near 1.4 nW, compared with ~3.5 nW for a monolayer. An eight-unit film remained near 1.3 nW but had a broader linewidth.

About one quarter of the assembled devices showed no discernible threshold-like response over the measured pump range, especially when cavity quality factors were below 800.

Beyond these cavity-performance results, the solution-processing approach supports film deposition across varied substrate shapes and materials, though the lasing-like measurements used an Ag/PMMA reflective substrate with silica microspheres.

Implications for Thin-Film Lasers

This work demonstrates room-temperature continuous-wave lasing-like emission from solution-processed bulk monolayer MoS2 films integrated into microsphere WGM cavities.

Solution-phase exfoliation and spray-coating techniques yield large-area films under ambient conditions and can, in principle, be applied to polymer and non-flat substrates, though those platforms were not tested for lasing-like emission here.

Combined with microsphere resonators, these films exhibit lasing-like signatures around an ultralow threshold-like crossover, including linewidth narrowing, pump-induced polarization selection, and measured quality factors above passive-cavity predictions near the excitonic transitions.

This material strategy avoids the flake-size limit of mechanical exfoliation and the high-temperature growth step used in CVD.

The authors state that the combined signatures strongly support a lasing interpretation, but definitive confirmation requires spatially and spectrally selective second-order coherence, g²(τ), measurements. The microscopic gain mechanism also remains unresolved, and the study did not establish polariton condensation because it lacked direct evidence of strong exciton-cavity coupling.

Source:
Dr. Noopur Jain

Written by

Dr. Noopur Jain

Dr. Noopur Jain is an accomplished Scientific Writer based in the city of New Delhi, India. With a Ph.D. in Materials Science, she brings a depth of knowledge and experience in electron microscopy, catalysis, and soft materials. Her scientific publishing record is a testament to her dedication and expertise in the field. Additionally, she has hands-on experience in the field of chemical formulations, microscopy technique development and statistical analysis.    

Citations

Please use one of the following formats to cite this article in your essay, paper or report:

  • APA

    Jain, Noopur. (2026, November 17). Stacked MoS₂ Monolayers Produce Ultralow-Threshold Lasing-Like Emission At Room Temperature. AZoM. Retrieved on November 17, 2026 from https://www.azom.com/news.aspx?newsID=66057.

  • MLA

    Jain, Noopur. "Stacked MoS₂ Monolayers Produce Ultralow-Threshold Lasing-Like Emission At Room Temperature". AZoM. 17 November 2026. <https://www.azom.com/news.aspx?newsID=66057>.

  • Chicago

    Jain, Noopur. "Stacked MoS₂ Monolayers Produce Ultralow-Threshold Lasing-Like Emission At Room Temperature". AZoM. https://www.azom.com/news.aspx?newsID=66057. (accessed November 17, 2026).

  • Harvard

    Jain, Noopur. 2026. Stacked MoS₂ Monolayers Produce Ultralow-Threshold Lasing-Like Emission At Room Temperature. AZoM, viewed 17 November 2026, https://www.azom.com/news.aspx?newsID=66057.

Tell Us What You Think

Do you have a review, update or anything you would like to add to this news story?

Leave your feedback
Your comment type
Submit

While we only use edited and approved content for Azthena answers, it may on occasions provide incorrect responses. Please confirm any data provided with the related suppliers or authors. We do not provide medical advice, if you search for medical information you must always consult a medical professional before acting on any information provided.

Your questions, but not your email details will be shared with OpenAI and retained for 30 days in accordance with their privacy principles.

Please do not ask questions that use sensitive or confidential information.

Read the full Terms & Conditions.